Study on tribological property of high thermal conductivity h-BN/PEEK composite

Expand
  • 1. Shanghai Research Institute of Materials,Shanghai 200437;
    2. Shanghai Research Key Laboratory for Engineering Materials Evaluation,Shanghai 200437;
    3. University of Shanghai for Science and Technology,Shanghai 200082

Received date: 2020-01-17

  Revised date: 2020-03-04

  Online published: 2020-10-23

Abstract

Hexagonal boron nitride (h-BN)/polyetheretherketone (PEEK) composites with different mass fractions were prepared by blending and high-temperature molding.The laser flash method was used to test the thermal conductivity of the composite.The universal mechanical tester and Rockwell hardness tester were used to test the mechanical properties of the composite.The friction and wear tester was used to test the tribological properties of the composite under different friction and lubrication conditions.The scanning electron microscope was used to observe the worn surface.The results shown that the thermally conductive filler h-BN improved the thermal conductivity and tribological properties of the composite.Compared with pure PEEK,the thermal conductivity of the composite was increased by 156% to 1.522W/(m·K).The friction coefficient of the composite was decreased by about 50% under dry conditions,the lowest being 0.22.Under water lubrication conditions,the wear volume was decreased almost by 80%.

Cite this article

Wang Wendong, He Changzhao, Zhang Chao, Zou Hua . Study on tribological property of high thermal conductivity h-BN/PEEK composite[J]. New Chemical Materials, 2020 , 48(8) : 66 -70 . DOI: 10.19817/j.cnki.issn 1006-3536.2020.08.014

References

[1] 潘炳力.先进高分子材料摩擦学[M].北京:国防工业出版社,2016,248-257.
[2] Huang X,Jiang P,Tanaka T.A review of dielectric polymer composites with high thermal conductivity[J].IEEE Electrical Insulation Magazine,2011,27(4):8-16.
[3] Li Q,Chen L,Gadinski M R,et al.Flexible high-temperature dielectric materials from polymer nanocomposites[J].Nature,2015,523(7562):576-579.
[4] 杜伯学,孔晓晓,肖萌,等.高导热聚合物基复合材料研究进展[J].电工技术学报,2018,33(14):3149-3159.
[5] 赵纯,张玉龙.聚醚醚酮[M].北京:化学工业出版社,2008,1-14.
[6] 戢炳强,吴冶平,张平,等.六方氮化硼/聚合物导热复合材料研究进展[J].高分子通报,2019(9):15-25.
[7] Ribeiro H,Trigueiro J P C,Lopes M C,et al.Enhanced thermal conductivity and mechanical properties of hybrid MoS2/h-BN polyurethane nanocomposites[J].J Appl Polym Sci,2018,135(30):46560.
[8] Tharajak J,Palathai T,Sombatsompop N.Recommendations for h-BN loading and service temperature to achieve low friction coefficient and wear rate for thermal-sprayed PEEK coatings[J].Surf Coat Tech,2017,321:477-483.
[9] Tharajak J,Palathai T,Sombatsompop N.Morphological and physical properties and friction/wear behavior of h-BN filled PEEK composite coatings[J].Surf Coat Tech,2015,273:20-29.
[10] 王文东,薛春,傅宇.PTFE/MoS2改性聚酯纤维织物复合材料摩擦性能[J].化工新型材料,2016,44(4):176-178.
[11] 杨新亚,张勇.氮化硼/碳纳米管/溴化丁基橡胶复合材料的力学和导热性能研究[J].化工新型材料,2018,46(3):70-74.
[12] 赵春宝,徐随春,赵玮,等.BT树脂/氮化硼导热复合材料的制备与性能研究[J].化工新型材料,2018,46(12):90-93.
[13] 于志强,姜月.颗粒填充环氧复合材料的摩擦学性能研究进展[J].材料工程,2016,44(3):114-121.
[14] 周文英,丁小卫.导热高分子材料[M].北京:国防工业出版社,2014,82-86.
[15] Khan M J,Wani M F,Gupta R.Tribological properties of glass fiber filled polytetrafluoroethylene sliding against stainless steel under dry and aqueous environments:enhanced tribological performance in sea water[J].Mater Res Express,2018,5(5):055309.
Options
Outlines

/