Optimization design of preparation condition for bagasse based GO by RSM

Expand
  • 1. School of Chemical and Environmental Engineering,Liaoning University of Technology, Jinzhou 121001;
    2. Huafei(Liaoning)Resources and Environment Technology Co.,Ltd., Jinzhou 121000;
    3. College of Engineering,Bohai University,Jinzhou 121013

Received date: 2020-09-27

  Revised date: 2021-01-24

  Online published: 2021-05-10

Abstract

Graphene oxide(GO) was prepared by using bagasse as base material,and through improved Hummers method.The preparation conditions of GO with bagasse as substrate were optimized by response surface methodology (RSM).The dosage of toner,dosage of potassium permanganate,dosage of concentrated sulfuric acid and ultrasonic time were selected as four variable factors.And the infrared characteristic absorption peak intensity of the prepared GO was taken as the response value.Then,data analysis was carried out using Design-Expert software.The optimum conditions for preparing GO from bagasse were as follows:carbon powder 3.39g,potassium permanganate 4.21g,concentrated sulfuric acid 20.68mL and ultrasonic time 7.75h.The results of scanning electron microscopy and infrared spectroscopy shown that GO prepared under these conditions had obvious lamellar structure,with characteristic peaks at 1500cm-1,2300cm-1,2400cm-1 and 3500cm-1,which were comparable to GO prepared by traditional materials.

Cite this article

Zhang Tingting, Fu Ying, Kong Xiangqing, Shan Fengjun, Yu Changwu, Xue Shaochen . Optimization design of preparation condition for bagasse based GO by RSM[J]. New Chemical Materials, 2021 , 49(3) : 269 -273 . DOI: 10.19817/j.cnki.issn 1006-3536.2021.03.060

References

[1] 祝智胜.温和碱法和离子液体耦合预处理甘蔗渣研究及乙醇发酵性能的评价[D].广州:华南理工大学,2012.
[2] 覃嵩蘅.基于灰分的广西蔗渣燃烧结渣特性研究[D].南宁:广西大学,2019.
[3] András B,Juliana A,Ágnes E F,et al.Alkali treatment of lignocellulosic fibers extracted from sugarcane bagasse:composition,structure,properties[J].Polymer Testing,2020,17:106549-106554.
[4] Lamounier K F R,Rodrigues P O,Pasquini D,et al.Ethanol production and other bioproducts by galactomyces geotrichum from sugarcane bagasse hydrolysate[J].Current Microbiology,2020,77(5):738-745.
[5] Tran Q T,Doan B T,Trinh N M A,et al.Synthesis of furfural from sugarcane bagasse by hydrolysis method using magnetic sulfonated graphene oxide catalyst[J].Vietnam Journal of Chemistry,2020,58(2):245-250.
[6] Aline A A C,Andre F,Adriane M F M,et al.Enzyme-aided xylan extraction from alkaline-sulfite pretreated sugarcane bagasse and its incorporation onto eucalyptus kraft pulps[J].Carbohydrate Research,2020,492:108003-108008.
[7] Marcano D C,Kosynkin D V,Berlin J M,et al.Improved synthesis of graphene oxide[J].ACS Nano,2010,4(8):4806-4814.
[8] Pinto A M,Gonçalves I C,Magalhães F D.Graphene-based materials biocompatibility:a review[J].Colloids & Surfaces B Biointerfaces,2013,111(6):188-202.
[9] Novoselov K S,Geim A K,Morozov S V,et al.Electric field effect in atomically thin carbon films[J].Science,2004,306(5696):666-669.
[10] Duy X L,Ksenia V B,Wala A A,et al.Gram-scale bottom-up flash graphene synthesis[J].Nature,2020,577:647-651.
[11] Gao Chong,Liu Shumei,Huo Wenjun.Optimization of forging process for aluminum alloy connecting rods based on response surface method[J].Hot Working Technology,2020,11(49):9-14.
[12] 张家豪,师超,邵亚薇,等.溶胶-凝胶二氧化硅微球粒径的响应曲面法优化研究[J].硅酸盐通报,2017,36(5):1470-1479.
[13] Zhang Jiahao,Shi Chao,Shao Yawei,et al.Optimization of response surface method for particle size of sol-gel silica microspheres[J].Chinese Ceramics Bulletin,2017,36(5):1470-1479.
[14] Jaswir I,Noviendri D,Taher M,et al.Optimization and formulation of fucoxanthin-loaded microsphere (F-LM) using response surface methodology (RSM) and analysis of its fucoxanthin release profile[J].Molecules,2019,24(5):947.
[15] Balandin A A,Ghosh S,Bao W Z,et al.Superior thermal conductivity of single-layer graphene[J].Nano letters,2008,3(3):902-907.
[16] Marcano D C,Kosynkin D V,Berlin J M,et al.Improved synthesis of graphene oxide[J].ACS Nano,2010,4(8):4806-4814.
[17] 王露.改进Hummers法制备氧化石墨烯及其表征[J].包装学报,2015,7(2):28-31;37.
Options
Outlines

/