PDF
摘要
海洋环境下,尤其热带海域常年处于高温、高湿、高盐雾和高紫外线状态,相对湿度一般在80%以上,因此飞机机匣的服役环境就更为恶劣。受海雾、海水飞溅等多种因素的影响,还要遭受发动机排出的烟气侵蚀,如果机匣等设备表面防护能力不足,极易产生腐蚀和发霉等问题,从而使传动系统的使用寿命缩短,影响发动机正常工作。海洋化工研究院有限公司研究了一种机匣用高防腐涂层体系,并确定了涂料配方。检测结果表明,该涂层体系具有良好的耐盐雾、耐湿热及耐介质等性能,能够有效地保护机匣不受腐蚀,延长使用寿命。
Abstract
In the marine environment,especially in the tropical sea,it is always in the state of high temperature,high humidity,high salt fog and high ultraviolet ray,and the relative humidity is generally over 80%.Therefore,the service environment of the casing is more severe.Under the influence of sea fog,sea water splashing and other factors,the casing is also subjected to the erosion of the exhaust gases from the engine.If the surface protection ability of the casing and other equipment is insufficient,it is easy to produce corrosion and mildew and other problems,thus shortening the service life of the transmission system and affecting the normal operation of the engine.To address this issue,a coating system with high corrosion resistance for casing was studied and the coating formula was determined.The test results showed that the coating system had good salt spray resistance,heat and humidity resistance and medium resistance,which could effectively protect the casing from corrosion and prolong its service life.
关键词
海洋环境
/
机匣
/
高防腐
/
涂层
Key words
the marine environment
/
casing
/
high corrosion resistance
/
coating
海洋环境下机匣用高防腐涂层的制备[J].
化工新型材料, 2023, 51(10): 145-149 DOI:10.19817/j.cnki.issn1006-3536.2023.10.012
[1] 伍小军,杨亚良.海洋工程重防腐涂料的要求及应用[J].涂层与防护,2021,42(1):8-10.
[2] 吴蔚.2020年国外航空科技发展综述[J].国防科技工业,2020,4(12):74-77.
[3] 续芯如,娄超云,王雅婷.海洋防腐涂料研究进展[J].玻璃,2022,49(2):22-26.
[4] Li Z,Ravenni G,H Bi,et al.Effects of biochar nanoparticles on anticorrosive performance of zinc-rich epoxy coatings[J].Progress in Organic Coatings,2021,158:106351-106365.
[5] Orlov M A,Polikarpova I A,Kalinnikov A N.Development and testing of polyurethane coating for protection of gas turbine engine blades[J].Solid State Phenomena,2021,316:868-872.
[6] 陆文明,赵宝华,周如东,等.海洋环境下直升机防腐底漆的研制[J].涂层与防护,2020,41(10):31-35.
[7] Wang X,Zhang X,Caldona E B,et al.Anticorrosive epoxy coatings containing ultrafine bamboo char and zinc particles[J].Journal of Environmental Chemical Engineering,2021,9(4):105707-105720.
[8] 李飞,张涵.石墨烯在防腐涂料中的应用分析及展望[J].当代化工研究,2022(2):41-43.
[9] 潘巍,李瑜,辛颉,等.颜填料配比及颜料体积浓度对聚硫改性环氧涂层防腐性能的影响[J].表面技术,2022,51(3):138-150.
[10] D'Alessandro O,Byrne C E,Selmi G,et al.Anticorrosive paint with a modified zeolite as functional pigment for SAE 1010 steel protection[J].Pigment and Resin Technology,2020,50(2):136-145.
[11] 杨柳,李保山.颜填料对乙烯基酯树脂重防腐涂料性能的影响[J].涂料工业,2020,50(7):6-12.
[12] Su N,Zhou F.Study of BiOI/BiOIO3 composite photocatalyst for improved sterilization performance of fluorocarbon resin coating(PEVE)[J].Chemical Physics Letters,2021,766:138329-138338.
[13] Ma Y,Zhang Y,Liu J,et al.GO-modified double-walled polyurea microcapsules/epoxy composites for marine anticorrosive self-healing coating[J].Materials & Design,2020,189:108547-108563.
[14] Nikalin D M,Merkulova Y I,Zheleznyak V G.Fluorine-containing polymer paints and arnishes in aviation[J].Russian Journal of General Chemistry,2021,91(6):1171-1177.
[15] 李文冠,张瑞志,罗方伟,等.改性石墨烯基填料在防腐涂料中的应用研究进展[J].涂料工业,2020,50(4):7-14.
[16] Ng Y H,Tay S W,Hong L.Formation of icephobic surface with micron-scaled hydrophobic heterogeneity on polyurethane aerospace coating[J].ACS Applied Materials & Interfaces,2018,10(43):37517-37528.