科学研究

不同长度CF/PEEK复合材料润湿性及摩擦学性能研究

展开
  • 1.山西医科大学口腔医学院口腔医院,太原030001;
    2.山西医科大学第一医院口腔多学科诊疗中心,太原030001;
    3.太原理工大学新型碳材料研究所,太原市030024
崔晓华(1993-),女,硕士研究生,主要从事口腔修复学方面的研究。

收稿日期: 2019-08-21

  修回日期: 2020-09-26

  网络出版日期: 2021-01-21

基金资助

山西省重点研发计划项目(201703D321027-1)

Study on wettability and tribological properties of PEEK composite reinforced by CF with different lengths

Expand
  • 1. School and Hospital of Stomatology,Shanxi Medical University,Taiyua 030001;
    2. Oral Multidisciplinary Medical Center of the First Hospital of Shanxi Medical University,Taiyuan 030001;
    3. Institute of New Carbon Materials,Taiyuan University of Technology,Taiyuan 030024

Received date: 2019-08-21

  Revised date: 2020-09-26

  Online published: 2021-01-21

摘要

以短切碳纤维为填料,采用注塑法分别制备长、短碳纤维/聚醚醚酮(CF/PEEK)复合材料;通过测量复合材料的水接触角探究其表面润湿性;通过摩擦磨损实验研究其摩擦学性能。结果表明,加入碳纤维后,复合材料表面接触角增大,纤维越长,接触角越大;CF/PEEK的摩擦系数及摩擦量均低于纯PEEK,长纤维CF/PEEK比短纤维CF/PEEK的摩擦系数和磨损量更低。说明碳纤维能起到减摩润滑的作用,使CF/PEEK复合材料的摩擦系数降低,碳纤维的长度也会影响复合材料的摩擦学性能,长纤维复合材料具有更好的耐摩擦性能。

本文引用格式

崔晓华, 李英, 刘夏青, 梁倩, 秦温, 马婧 . 不同长度CF/PEEK复合材料润湿性及摩擦学性能研究[J]. 化工新型材料, 2020 , 48(12) : 146 -149 . DOI: 10.19817/j.cnki.issn 1006-3536.2020.12.035

Abstract

With chopped carbon fiber(CF) as filler,long and short CF/polyetheretherketone (CF/PEEK) composite materials were prepared by injection molding method.The surface wettability of the materials was Explored by measuring the water contact angle.The tribological properties were studied through friction and wear experiments.The results shown that after adding CF,the surface contact angle of the materials increased,and the longer the fiber,the larger the contact angle.The friction coefficient and friction amount of CF/PEEK were lower than pure PEEK,and the friction coefficient and wear amount of long fiber CF/PEEK were lower than that of short fiber CF/PEEK.It shown that CF can play the role of anti-friction and lubrication,so that the friction coefficient of CF/PEEK was reduced.The length of CF will also affect the tribological performance.Long fiber materials had better friction resistance performance.

参考文献

[1] Xiaoming C.Development and application of special engineering plastics polyetheretherketone[J].Eng Plastics App,2004,32(10):63-66.
[2] Jaime M,Marisol M G.The use of PEEK nanorod arrays for the fabrication of nanoporous surfaces under high temperature:SiNx example[J].Nanoscale,2012,4(18):5608.
[3] Kulkarni A G,Hee H T,Wong H K.Solis cage (PEEK) for anterior cervical fusion:preliminary radiological results with emphasis on fusion and subsidence[J].The Spine Journal,2007,7(2):205-209.
[4] Camarini E T,Tomeh J K,Dias R R,et al.Reconstruction of frontal bone using specific implant polyether-ether-ketone[J].Journal of Craniofacial Surgery,2011,22(6):2205-2207.
[5] Williams D.Polyetheretherketone for long-term implantable devices[J].Med Device Technol,2008,19(1):8,10.
[6] Deng Y,Zhou P,Liu X,et al.Preparation,characterization,cellular response and in vivo osseointegration of polyetheretherketone/nano-hydroxyapatite/carbon fiber ternary biocomposite[J].Colloids & Surfaces B Biointerfaces,2015,136(4):64-73.
[7] Kurtz S M,Devine J N.PEEK biomaterials in trauma,orthopedic,and spinal implants[J].Biomaterials,2007,28(32):4845-4869.
[8] 武扬.短碳纤维增强型聚醚醚酮复合体的力学性能研究[D].太原:山西医科大学,2017.
[9] Garcia-Gonzalez D,Rodriguez-Millan M,Rusinek A,et al.Investigation of mechanical impact behavior of short carbon-fiber-reinforced PEEK composites[J].Composite Structures,2015,133(2-3):1116-1126.
[10] 刘瑞,李明贺,及昕,等.碳纤维增强型聚醚醚酮植入下颌骨单层骨皮质缺损模型白兔体内后的生物相容性评价[J].吉林大学学报(医学版),2014,40(3):569-573.
[11] Qin W,Li Y,Ma J,et al.Mechanical properties and cytotoxicity of hierarchical carbon fiber-reinforced poly (ether-ether-ketone) composites used as implant materials[J].Journal of the Mechanical Behavior of Biomedical Materials,2019,89:227-233.
[12] Mahjoubi H,Buck E,Manimunda P,et al.Surface phosphonation enhances hydroxyapatite coating adhesion on polyetheretherketone and its osseointegration potential[J].Acta Biomaterialia,2016,47:149-158.
[13] Guehennec L L,Lopez-Heredia M A,Enkel B,et al.Osteoblastic cell behaviour on different titanium implant surfaces[J].Acta Biomaterialia,2008,4(3):535-543.
[14] 吴欣鑫.碳纤维增强聚醚醚酮复合材料及其摩擦磨损性能研究[D].南京:南京理工大学,2012.
[15] 朱艳吉,陈晶,姜丽丽,等.组装改性碳纤维增强聚醚醚酮复合材料的摩擦学性能[J].润滑与密封,2015,40(8):61-65.
[16] Ajami S,Coathup M J,Khoury J,et al.Augmenting the bioactivity of polyetheretherketone using a novel accelerated neutral atom beam technique[J].Journal of Biomedical Materials Research Part B:Applied Biomaterials,2017,105(6):1438-1446.
[17] 姚光督,王文东,沈景凤,等.PTFE微粉/CF改性PEEK复合材料的摩擦磨损性能[J].材料科学与工艺,2018,26(3):59-65.
[18] Chen B B,Wang J Z,Yan F Y.Comparative investigation on the tribological behaviors of CF/PEEK composites under sea water lubrication[J].Tribology International,2012,52(3):170-177.
[19] 胡婕.PEEK及碳纤维增强PEEK的性能研究[D].上海:东华大学,2010.
[20] 宋晓东,杨方,齐乐华,等.碳纤维长度与取向对纸基摩擦材料热负荷及摩擦学性能影响[J].摩擦学学报,2014,34(1):65-72.
Options
文章导航

/