新材料与新技术

石墨烯和四氧化三铁共同改性环氧树脂固体润滑涂层及其性能

展开
  • 上海大学材料科学与工程学院,上海 200444
金叶(1995-),男,硕士研究生,主要研究固体润滑耐磨涂层,E-mail: awesomejy@outlook.com。

网络出版日期: 2020-12-07

基金资助

上海市自然科学基金项目(15ZR1415300)

Property of EP solid lubricant coating modified by graphene and Fe3O4

Expand
  • School of Materials Science and Engineering,Shanghai University,Shanghai 200444

Online published: 2020-12-07

摘要

采用化学氧化还原法制备石墨烯,并与Fe3O4共同填充改性环氧树脂制备固体润滑涂层,通过红外光谱、X射线衍射、透射电镜表征石墨烯结构,通过热重分析仪和摩擦磨损试验机分别研究涂层的耐热性能和在干摩擦条件下的摩擦磨损性能,结果表明:制备的石墨烯为半透明轻纱状单片层结构,与Fe3O4一起填充环氧涂层能提高耐热性和减摩耐磨性能,最佳总填充量为10%。其中石墨烯填充量越大,涂层减摩效果越显著,而Fe3O4的填充也具有协同作用,当两者等量填充时涂层减摩耐磨性能最优。对涂层粘着磨损机理进行分析。

本文引用格式

金叶, 刘海彬, 杨健伟, 吴兆辉, 郭强 . 石墨烯和四氧化三铁共同改性环氧树脂固体润滑涂层及其性能[J]. 化工新型材料, 2020 , 48(11) : 103 -107 . DOI: 10.19817/j.cnki.issn 1006-3536.2020.11.023

Abstract

Graphene was prepared by chemical oxidation-reduction method and filled with Fe3O4 to prepare solid lubricating coating.The structure of graphene was characterized by FTTR,XRD and TEM.The heat resistance and tribology properties of coatings were studied by TGA and M-2000 wear tester under dry condition respectively.The results showed that the prepared graphene was a light yarn like translucent sheet structure,and the heat resistance and antifriction and wear resistance of the EP coating could be improved by filling with graphene and Fe3O4,the best total amount of filler was 10%.The larger the amount of graphene was,the more remarkable the friction reduction effect of the coating was,and the Fe3O4 filling also had a synergistic effect.The friction and wear resistance of the coating was the best when they were filled with the same amount.The adhesive wear mechanism of the coating was analyzed.

参考文献

[1] 丁军,马吉强,薛群基.纳米Al2O3填充端异氰酸酯基聚丁二烯橡胶-环氧树脂复合涂层的干滑动摩擦磨损性能研究[J].摩擦学学报,2006,26(4):314-319.
[2] Pan Guoliang,Guo Qiang,Jian Ding,et al.Tribological behaviors of graphite/epoxy two-phase composite coatings[J].Tribology International,2010,43(8):1318-1325.
[3] 谢卫刚,赵东林,景磊,等.石墨烯/环氧树脂复合材料的制备与力学性能[J].高分子材料科学与工程,2012(9):129-132.
[4] 王莹莹,郁惠敏,王晓,等.含石墨烯仿生滑液对ZrO2陶瓷人工关节材料的润滑作用研究[J].摩擦学学报,2018,38(3):319-326.
[5] Zhang J,Yang H,Shen G,et al.Reduction of graphene oxide via L-ascorbic acid[J].Chemical Communications,2010,46(7):1112-4.
[6] Schniepp H C,Li J L,McAllister M J,et al.Functionalized single graphene sheets derived from splitting graphite oxide[J].J Phys Chem B,2006,110:8535-8539.
[7] Park S,An J,Jung I,et al.Colloidal suspensions of highly reduced graphene[J].Solid State Communications,2007,143(1-2):92-100.
[8] 胡春华,杨春燕,刘庆存,等.纳米Al2O3-Fe3O4/FeS固体润滑复合层减摩润滑机理[J].材料热处理学报,2013,34(6):130-135.
[9] Tong Ruili,Zhao Nana,Wang Xiangying,et al.Preparation of Fe3O4 nanoparticles and their purification of oil-bearing wastewater[J].Chemical Engineering,2009,37(7):47-50.
[10] Zhou Xiaoli,Bi Hong.Hydrothermal synthesis and characterization of magnetic Fe3O4 nanoparticles[J].Journal of Anhui University:Natural Science Edition,2006,30(2):75-80.
[11] Hummers Jr W S,Offeman R E.Preparation of graphitic oxide[J].Journal of the American Chemical Society,1958,80:1339.
Options
文章导航

/