新材料与新技术

干喷-凝胶法制备可调控PAN原丝表面形貌的研究

展开
  • 1.中国科学院山西煤炭化学研究所,中国科学院炭材料重点实验室,太原030001;
    2.中国科学院大学,北京100049;
    3.中国科学院山西煤炭化学研究所,碳纤维制备技术国家工程实验室,太原030001
魏慧卿(1968-),男,博士研究生,高级工程师,主要从事高性能碳纤维及复合材料方面的研究。

收稿日期: 2019-12-17

  修回日期: 2021-01-29

  网络出版日期: 2021-06-10

基金资助

山西省自然科学基金面上项目(201801D121113)。

Research on tuning the surface morphology of PAN fiber by dry-jet gel-spinning

Expand
  • 1. CAS Key Laboratory of Carbon Materials,Institute of Coal Chemistry,Chinese Academy of Sciences,Taiyuan 030001;
    2. University of Chinese Academy of Sciences,Beijing 100049;
    3. National Engineering Laboratory for Carbon Fiber Technology,Institute of Coal Chemistry, Chinese Academy of Sciences,Taiyuan 030001

Received date: 2019-12-17

  Revised date: 2021-01-29

  Online published: 2021-06-10

摘要

采用干喷-凝胶方法研究了不同凝胶浴中制备的聚丙烯腈(PAN)原丝纤维的表面形貌及力学性能,该方法除了制备常规光滑表面的原丝外,也可以制备出表面带有平行沟槽结构形貌的原丝,并且沟槽深浅可调。研究发现,通过控制凝胶浴种类、温度、组成、牵倍等条件可以调控PAN原丝纤维的形貌和力学性能。相比乙醇凝胶浴,在甲醇中更容易获得高牵倍和力学性能优良的原丝纤维。由于干喷-凝胶法结合了干喷湿纺和凝胶纺丝的优点,它具有高效制备高性能碳纤维的巨大潜力。

本文引用格式

魏慧卿, 安锋, 周普查, 刘耀东, 吕春祥 . 干喷-凝胶法制备可调控PAN原丝表面形貌的研究[J]. 化工新型材料, 2021 , 49(5) : 84 -87 . DOI: 10.19817/j.cnki.issn 1006-3536.2021.05.019

Abstract

The morphology and mechanical property of polyacrylonitrile (PAN) fibers prepared in different gel coagulation baths were investigated using dry-jet gel-spinning technique,which could not only produce routine fibers with smooth surface but also ones with tuning parallel grooved surface.It indicated that the variety,temperature and constitute of gel coagulation bath all could significantly influence fiber surface morphology and its mechanical property.Compared with ethanol bath,higher mechanical properties of PAN fibers could be obtained in methanol due to higher draw radios.Because it combined advantages of dry-jet spinning and gel spinning,dry-jet gel-spinning technique held a huge potential to produce high performance carbon fibers efficiently.

参考文献

[1] An F,Zhou P C,Lu C X,et al.Tuning the surface grooves of carbon fibers by dry-jet gel-spinning[J].Carbon,2019,143:200-203.
[2] Li W J,Hao J,Zhou P C,et al.Solvent-solubility-parameter-dependent homogeneity and sol-gel transitions of concentrated polyacrylonitrile solutions[J].Journal of Applied Polymer Science,2017,134:45405-45413.
[3] 贺福.高性能碳纤维原丝与干喷湿纺[J].高科技纤维与应用,2004,29:6-12.
[4] 徐梁华.PAN干湿法纺丝工艺中原丝的表面沟槽形态[J].高科技纤维与应用,2001,26:21-24.
[5] Liu F J,Fan L D,Wang H J,et al.Zhenping,Study of the microstructure and the mechanical properties of high strength PAN-based carbon fibers[J].Journal of Functional Materials,2007,38:1723-1727.
[6] Wang T Y,Chang H C,Chiu Y T,et al.The index of dry-jet wet spinning for polyacrylonitrile precursor fibers[J].Journal of Applied Polymer Science,2015,132(2):41265-41274.
[7] Zhang M,Zhu B,Wang C,et al.Surface and fracture morphologies of carbon fibers observed by SEM[J].Journal of Functional Materials,2010,41:1731-1733.
文章导航

/