压力、温度和湿度均会影响动力电池系统性能的发挥,环境条件的滥用更是会影响其安全性。所以应加强模组夹具的设计,使其在充放电过程中维持在合适的压力范围内,这能保持电芯的一致性以提升系统的循环寿命;电池系统也应充分考虑密封设计的耐久性,并对可能的水汽侵入做好防护,各种可靠性实验后也应进行气密性测试。这样才能应对电动汽车复杂多样的运行环境,给使用者带来良好的使用体验。
Pressure,temperature and humidity will affect the performance of lithium battery power system(REESS),and the abuse of environmental conditions will even affect its safety.Therefore,the design of the module fixture should be strengthened so that it is maintained within a suitable pressure range during the charge and discharge process.This can maintain the consistency of the battery cells to improve the cycle life of the system.The battery system should also fully consider the durability of the seal design,and to protect against possible water vapor intrusion.Air tightness testing should also be performed after various reliability experiments.In this way,it can cope with the complex and diverse operating environment of electric vehicles and bringed a good user experience to users.
[1] 中国电子科技集团公司第十八研究所.GB/T 31484—2015.电动汽车用动力蓄电池循环寿命要求及试验方法[S].北京:中国标准出版社,2015:4.
[2] 中国汽车技术研究中心.GB/T 31485—2015.电动汽车用动力蓄电池安全要求及试验方法[S].北京:中国标准出版社,2015:6-8.
[3] 中国汽车技术研究中心.GB/T 31486—2015.电动汽车用动力蓄电池电性能要求及试验方法[S].北京:中国标准出版社,2015:4-7.
[4] 中国汽车技术研究中心.GB/T 31467.3—2015.电动汽车用锂离子动力蓄电池包和系统 第3部分:安全性要求及测试方法[S].北京:中国标准出版社,2015:9.
[5] 宋文吉,陈永珍,吕杰,等.锂离子电池容量衰减机理研究进展[J].新能源进展,2016,4(5):364-372.
[6] Mussa A S,Klett M,Göran L,et al.Effects of external pressure on the performance and ageing of single-layer lithium-ion pouch cells[J].Journal of Power Sources,2018,385:18-26.
[7] 邹舜章.压力对软包锂离子电池性能的影响及对策研究[D].长沙:湖南大学,2017.
[8] 黄海江.锂离子电池安全性研究及影响因素分析[D].上海:中国科学院上海微系统与信息技术研究所,2005.
[9] 张磊.锂离子电池安全性影响因素研究[D].秦皇岛:燕山大学,2012.
[10] 王绥军,傅凯,官亦标,等.软包磷酸铁锂电池低温热安全性能研究[J].储能科学与技术,2016,5(2):204-209.
[11] 任东生,冯旭宁,韩雪冰,等.锂离子电池全生命周期安全性演变研究进展[J].储能科学与技术,2018,7(6):957-966.
[12] Grandjean T,Barai A,Hosseinzadeh E,et al.Large format lithium ion pouch cell full thermal characterisation for improved electric vehicle thermal management[J].Journal of Power Sources,2017,359:215-225.
[13] Hendricks C,Williard N,Mathew S,et al.A failure modes,mechanisms,and effects analysis (FMMEA) of lithium-ion batteries[J].Journal of Power Sources,2015,297:113-120.
[14] Martin W,Jörg K,Drik U S.Investigation of the influence of different bracing of automotive pouch cells on cyclic liefetime and impedance spectra[J].Journal of Energy Storage,2019,21:149-155.
[15] Choi Y H,Lim H K,Seo J H,et al.Development of standardized battery pack for next generation PHEVs in considering the effect of external pressure on lithium-ion pouch cells[J].SAE Int J Alt Power,2018,7(3):195-205.
[16] 李颖,杨喜存,单军勇.低温环境试验条件恢复的防凝露问题[J].装备环境工程,2013,10(5):112-115.
[17] 仲文锦.凝露造成高低压开关柜的故障分析[J].装备制造技术,2017(1):186-194.
