Please wait a minute...
 首页  期刊简介 期刊订阅 广告合作 联系我们
 
最新录用  |  当期目录  |  过刊浏览  |  热点文章  |  阅读排行
化工新型材料  2018, Vol. 46 Issue (8): 60-62    
  新材料与新技术 本期目录 | 过刊浏览 | 高级检索 |
水性环氧树脂制备条件对其粒径与稳定性的影响
谷雨1, 唐伯明1,2, 何丽红2,3, 杨帆2,3, 田春玲2,3
1.同济大学道路与交通工程教育部重点实验室,上海201804;
2.重庆交通大学交通土建材料国家地方联合工程试验室,重庆400074;
3.重庆交通大学材料科学与工程学院,重庆400074
Influence of preparation condition of waterborne epoxy resin on its particle size and stability
Gu Yu1, Tang Boming1,2, He Lihong2,3, Yang Fan2,3, Tian Chunling2,3
1.The Key Laboratory of Road and Traffic Engineering,Ministry of Education,Shanghai 201804;
2.National Joint Engineering Laboratory of Traffic and Civil Engineering,Chongqing Jiaotong University,Chongqing 400074;
3.College of Materials Science and Engineering,Chongqing Jiaotong University,Chongqing 400074
下载:  PDF (1133KB) 
输出:  BibTeX | EndNote (RIS)      
摘要 采用环氧树脂E-51和聚乙二醇(PEG)合成了环氧乳化剂,制得水性环氧树脂,以激光粒度分析仪、高速离心法和贮存观察法分别分析了水性环氧树脂粒径大小与分布、离心稳定性和贮存稳定性的影响因素。结果表明:环氧乳化剂中PEG的分子量、E-51与PEG的物料比以及水性环氧树脂的制备温度、分散砂磨机转速对水性环氧树脂的粒径大小与稳定性有较明显的影响规律,但对水性环氧树脂粒径分布的影响基本无规律。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
谷雨
唐伯明
何丽红
杨帆
田春玲
关键词:  相反转法  水性环氧树脂  聚乙二醇  粒径大小与分布  分层容积率    
Abstract: The epoxy resin E-51 and the polyethylene glycol (PEG) were adopted to synthesize the epoxy emulsifier,by which the epoxy resin E-51 was emulsified,and the waterborne epoxy resin was obtained.Influential factors of the particle size and distribution,the centrifugal and storage stability of resin were separately analyzed by the laser particle analyzer,the high speed centrifugal method and storage-observing method.Results showed that there were obvious influential laws of the molecular weight of PEG,the material ratio of E-51 and PEG in the epoxy emulsifier and the preparing temperature,the rotating speed of dispersing sand mill on the particle size and stability of resin,but there was nearly no influential law of them on the distribution of particle size.
Key words:  phase-inversion method    waterborne epoxy resin    polyethylene glycol    particle size and distribution    layered volume ratio
收稿日期:  2017-03-15                     发布日期:  2018-09-18      期的出版日期:  2018-08-20
基金资助: 交通运输部建设科技项目(2014318346140)
作者简介:  谷雨(1988-),男,博士研究生,工程师,主要研究方向为新型筑路材料。
引用本文:    
谷雨, 唐伯明, 何丽红, 杨帆, 田春玲. 水性环氧树脂制备条件对其粒径与稳定性的影响[J]. 化工新型材料, 2018, 46(8): 60-62.
Gu Yu, Tang Boming, He Lihong, Yang Fan, Tian Chunling. Influence of preparation condition of waterborne epoxy resin on its particle size and stability. New Chemical Materials, 2018, 46(8): 60-62.
链接本文:  
http://www.hgxx.org/CN/  或          http://www.hgxx.org/CN/Y2018/V46/I8/60
[1] 刘小平,郑天亮.环氧树脂的水性化技术[J].涂料工业,2000,30(10):33-35.
[2] 顾宇昕,黄玉惠,廖兵,等.离聚体水基微乳液化的研究——聚苯醚离聚体微乳化过程的相反转[J].高分子学报,1999(4):477-482.
[3] 杨振忠,许元泽,徐懋,等.环氧树脂微粒化水基化体系[J].高分子通报,1997(9):190-194.
[4] 施雪珍,陈铤,顾国芳.水性环氧树脂乳液的研制[J].功能高分子学报,2002(15):306-310.
[5] Zhang Z Y,Huang Y H,Liao B,et al.Studies on particle size of waterborne emulsions derived from epoxy resin[J].Eur Polym J,2001,37(6):1207-1211.
[6] 李亮,王平华,刘春华,等.水性环氧树脂的制备及表征[J].涂料工业,2011,41(2):17-20.
[7] 刘晓东,陈志明,董劲.单组分水性环氧乳液的合成研究[J].应用化工,2007,36(1):68-71.
[8] 张肇英,黄玉惠,廖兵,等.对-氨基苯甲酸改性环氧树脂的性能表征及乳化性质[J].高等学校化学学报,2002,23(5):974-978.
[9] 张力,张凯.硅氧烷改性环氧树脂复合水分散液的制备及粒径研究[J].高分子材料科学与工程,2006,22(2):63-65.
[10] 樊大力,韩兆让,刘兆滨,等.环氧树脂复合水分散乳液的制备及其性能研究[J].化学研究,2007,18(3):60-64.
[11] 李亮,王平华,刘春华,等.水性环氧树脂的制备及表征[J].涂料工业,2011,41(2):17-20.
[12] 夏新年,刘玉堂,熊远钦,等.水性环氧乳液的研制[J].涂料工业,2004,34(2):46-49.
[13] 张道洪,周继亮,刘娜.水溶性双酚A型环氧树脂乳液的制备[J].粘接,2008,29(2):30-32.
[14] 倪维良,柳云琪,陈克磊.水性环氧树脂专用乳化剂的制备及性能研究[J].涂料工业,2010,40(12):61-64.
[15] 古绪鹏,吴礼龙,杨建国,等.水性环氧乳液制备的影响因素[J].上海涂料,2010,48(11):1-4.
[1] 付蕾, 王忠, 陈立贵, 贾仕奎, 张显勇. 制备方法对PEG/石墨烯复合相变材料热性能的影响[J]. 化工新型材料, 2018, 46(3): 134-137.
[2] 曹元龙, 丁媛媛, 桑欣欣, 石刚, 张丽萍, 倪才华. 表面改性羧甲基壳聚糖栓塞微球的制备及性能研究[J]. 化工新型材料, 2018, 46(1): 214-217.
[1] Xiao Yu, Lv Cheng, Zhang Guoyou. Epoxy resin modified by PMMA microsphere wrapped by graphene oxide[J]. New Chemical Materials, 2017, 45(9): 62 -64 .
[2] Su Wei, Ran Meng, Zhang Ai, Sun Yan. Preparation of sulfur-doped microporous carbon and its adsorption property[J]. New Chemical Materials, 2018, 46(4): 161 -164 .
[3] Fan Yingge. Study on preparation and optical property of one-dimensional ZnO nanorod by sol-gel dip coating[J]. New Chemical Materials, 2018, 46(4): 189 -192 .
[4] Zheng Zhen, Ding Chengli, Li Huiping, Fu Jingjing. Synthesis and property of hydrophobic functionalized cotton linter cellulose/SiO2 composite aerogel[J]. New Chemical Materials, 2018, 46(4): 230 -233 .
[5] Lin Yuan. Research status and application progress of thin film solar cells[J]. New Chemical Materials, 2018, 46(6): 57 -60 .
[6] Chen Kai, Wang Qiang, Sun Ting, You Min, Xia Zuxi. Research on impact of chemical etching on superhydrophobic surface property[J]. New Chemical Materials, 2018, 46(6): 206 -209 .
[7] Zheng Dandan, Chang Wei, Xi Qiang, Yu Cuihua. Preparation and photocatalytic activity of Cd1-xZnxS[J]. New Chemical Materials, 2018, 46(5): 181 -183 .
[8] Han Fei, Zong Yue, Di Song, Wang Shaopo. Adsorption of copper ion in aqueous solution by activated boron nitride[J]. New Chemical Materials, 2018, 46(5): 195 -198 .
[9] Chang Lin, Zhao Yuntao, Bi Yinping, Ren Yiwei. Preparation and characterization of sodium polystyrene sulfonate grafted polysulfone forward osmosis membrane[J]. New Chemical Materials, 2018, 46(7): 114 -117 .
[10] Cai Tingting, Liu Rongwei, Wang Yuanyuan, Zhai Yongxing, Duan Ze, Zhang Jian. Preparation and electrochemical performance test of nickel cobalt sulfide/carbon microsphere electrode[J]. New Chemical Materials, 2018, 46(8): 119 -122 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
京ICP备09035943号-38
版权所有 © 《化工新型材料》编辑部
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn